To ensure that the Fire rating of the
door is maintained it is important that
the hardware used should also be fire
rated. Please find below the hardware
recommended by us:
Technical specification for
the Hardware required
1
Ball Bearing Hinges:
Stainess Steel Ball Bearing
type hinges
Size 102mm x 102mm x3mm-(for
120 Mnts Wooden fire door).
Size 102mm x 89mm
x2.5mm-(for 60 Mnts fire
door).
2
Concealed Door Closer with
Hold open -
Concealed Door Closer (Size
4) installed in the door
leaf or frame, tested on
fire door assemblies in
accordance with Australian
Standard AS 1905.1:1997 Fire
Resistant Door sets.
Adjustable closing speeds
and latch action adjustable.
Non – handed, with slide
channel. Suitable for
internal door width up to
1250mm and min door
thickness required 45mm,
maximum door opening angle
is 110 deg & door weight 85
kgs.
3
Overhead Door Closer:
Door Closer tested on fire
door assemblies in
accordance with Australian
Standard AS 1905.1:1997 Fire
Resistant Door sets.
Adjustable closing speeds
and latch action adjustable.
Non – handed, with slide
channel.
4
Architectural Euro profile
Mortice lock with 55mm
backset.
5
The Lever Handle should have
a 54mm rose available both
sprung and unsprung supplied
with bolt through fixings.
The furniture fixings when
fitted are concealed on both
sides of the door. All
furniture is supplied in
Grade 304 / 316 Stainless
Steel.
6
Stainless Steel Flush bolt
manual type 200 (bottom)
300(top).
Silicon side seal suitable
for wooden frame and minimum
gap required is 3mm. Helps
prevent smoke & flame
passage at temp up to &
exeeding 650 deg F. self
extinguishing & non toxic.
Un effected by sun light,
ozon & ultravoilet rays,
impervious to fungus &
mildew, will not deteriorate
under normal exposure, smoke
tested by WYLE laboratories,
meets FAR 25.853
airworthiness standard for
compartment interiors, air
infiltration tested in
accordance with ASTM E 283
1984 & SDI 116. (One roll is
20running feet)
Auto. Door Bottom Seal:
Concealed type suitable for
wooden doors. Smooth action
automatic door bottoms
consist of an aluminum case
which surrounds a movable
drop bar seal. The drop bar
seal is actuated by a
plunger which contacts the
door is closing, forcing the
drop bar seal down against
the floor. The plunger
requires low closing force
to actuate the drop bar
seal. The door gap under a
door up to 3 /4”, all models
can be trimmed down as much
as 2”.
